Volume 4, Issue 2 (5-2017)
JROS 2017, 4(2): 0-0 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Moghtadaei M, Farahini H, Yeganeh A, Shahsavari Poor A, Askari A, Aminizadeh S et al . Is it Safe to Use a Six-Degree Distal Femoral Valgus Cut in All Genu Varus Patients with Total Knee Arthroplasty?. JROS 2017; 4 (2)
URL: http://jros.iums.ac.ir/article-1-210-en.html
URL: http://jros.iums.ac.ir/article-1-210-en.html
Mehdi Moghtadaei 
1, Hosein Farahini1 , Ali Yeganeh1 , Ali Shahsavari Poor1 , Alireza Askari1 , Sina Aminizadeh1 , Mehrdad Bahrabadi1
1, Hosein Farahini1 , Ali Yeganeh1 , Ali Shahsavari Poor1 , Alireza Askari1 , Sina Aminizadeh1 , Mehrdad Bahrabadi1
1- Bone and Joint Reconstruction Research Center, Shafa Orthopedic Hospital, Iran University of Medical Sciences, Tehran, Iran
Abstract: (3879 Views)
Background: During a total knee arthroplasty, it is common to make a distal femoral cut based on the femoral mechanical-anatomical angle (FMA), which in most patients is six degrees. However, in patients with a higher FMA, there is not yet a consensus between surgeons regarding the degree of the cutting angle.
Subject:
Knee surgery
Received: 2019/09/9 | Accepted: 2017/05/15 | Published: 2017/05/15
Received: 2019/09/9 | Accepted: 2017/05/15 | Published: 2017/05/15
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
Copyright © The Author(s);
This is an open access article distributed under the terms of the Creative Commons Attribution License (CC-By-NC), which permits use, distribution, and reproduction in any medium, provided the original work is properly cited and is not used for commercial purposes.
Contact Information
